Solenoid, Variable Valve Timing: Removal: Left

Disconnect and isolate the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness connector (2) from the Inlet Air Temperature (IAT) sensor.
Loosen the clamp (1) at the throttle body.
Loosen the clamp (4) at the air cleaner body.
Remove the air inlet hose (3).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Mark the Variable Valve Timing (VVT) solenoid connectors (1) with a paint pen or equivalent so that they may be installed to their original locations.
Mark the intake VVT solenoid (4) and the exhaust VVT solenoid (2) with a paint pen or equivalent so that they may be installed to their original locations.
Disconnect the wire harness connector (1) from the VVT solenoid.
Remove the VVT solenoid mounting bolts (3).

Courtesy of CHRYSLER GROUP, LLC
Pull the VVT solenoid from the cylinder head cover.
The seal (1) can be reused if not damaged.