Adjuster, Seat Belt Turning Loop: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Remove the upper trim from the inside of the B-pillar (2). Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL .
- Remove the nut (3) that secures the seat belt turning loop (4) to the stud (1) on the height adjuster.
- Remove the seat belt turning loop from the height adjuster.
- Remove the screw (1) that secures the upper end of the seat belt turning loop adjuster to the upper inner B-pillar (2).
- Pull the turning loop adjuster upward and away from the B-pillar far enough to disengage the tab (3) on the lower end of the adjuster from the hole in the B-pillar.
- Remove the seat belt turning loop adjuster from the B-pillar.