Removal And Installation

REMOVAL 

1. Remove the left front tire and wheel. Refer to REMOVAL AND INSTALLATION .
2. Partially remove the front half of the left wheelhouse splash shield to gain access to the sensor. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

3. Disconnect the wire harness connector (1) from the manifold air pressure sensor connector.

   Courtesy of CHRYSLER GROUP, LLC

4. Rotate 90° counter clockwise and remove the sensor (1).
5. Clean intake manifold mating surface.

INSTALLATION 

1. Install the manifold air pressure sensor and turn it 90 degrees clockwise.
2. Connect the wire harness connector to the manifold air pressure sensor.
3. Install the front splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
4. Install tire and wheel. Refer to REMOVAL AND INSTALLATION .