Removal And Installation: Front: Installation
- Position the seat belt buckle lower anchor (1b) to the bracket on the inboard rear corner of the front seat.
- Route the seat belt switch pigtail wire (2) beneath the seat and engage it with the retainers on the underside of the front seat cushion.
- Connect the seat belt switch pigtail wire connector (3) to the seat wire harness.
- Install the screw (1a) that secures the buckle lower anchor (1b) to the seat bracket. Tighten the screw to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Install the left or right front seat into the vehicle. Refer to SEAT, FRONT, REMOVAL AND INSTALLATION .
- Do not connect the negative battery cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to SUPPLEMENTAL RESTRAINT SYSTEM VERIFICATION TEST