LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Transmission Control (TCM) >> Module Programming >> Electronic Control Modules (Service Information) >> TCM Programming - 948TE
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TCM Programming - 948TE

PROGRAMMING THE TRANSMISSION CONTROL MODULE (TCM) 

NOTE:

When replacing a Transmission Control Module (TCM), the TCM must be programmed.

NOTE:

Failure to properly program the TCM may result in the illumination of the Malfunction Indicator Lamp (MIL) and setting Diagnostic Trouble Codes (DTC).

NOTE:

While performing the TCM programming procedure, the vehicle battery must be maintained between 10 and 16 volts. Ambient temperature must be between 0°C (32°F) and 60°C (140°F).

  1. Using the scan tool and Dealer Connect or Service Library, download the appropriate TCM flash file to the scan tool.
  2. Turn the Ignition ON, Engine not running.
  3. Make sure the gear selector is in the PARK position.
  4. Following the menu on the scan tool, program the TCM.
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit or if a new transmission has been installed, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU.

    Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under "Guided Diagnostics" tab.

  5. Using a scan tool, follow the on-screen instructions to perform the Vin Verification procedure. This only needs to be done if a new ECU or a new transmission has been installed.
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to perform the Valve Body Solenoid Learn procedure. Failure to perform the Valve Body Solenoid Learn procedure will result in reduced shift quality.

    Using a scan tool, follow the on-screen instructions to perform the Valve Body Solenoid Learn procedure.

    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to perform the TCM Adaptation procedure. Failure to perform the TCM Adaptation procedure will result in reduced shift quality.

    Perform the TCM ADAPTATION procedure. Refer to TCM ADAPTATION - 948TE AND 9HP48 .

  6. With the scan tool, erase DTCs.
  7. With the scan tool, read TCM DTCs.

    Does the scan tool display any DTCs?

    Yes 

    • Perform the appropriate diagnostic procedure(s).

    No 

scientia non olet · About LEMON Manuals