LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Module, Wireless Charging Pad >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
    GC0202738Courtesy of CHRYSLER GROUP, LLC
  3. Remove the wireless charging pad mat (1).
    GC0202719Courtesy of CHRYSLER GROUP, LLC
  4. Release the retaining tabs (2) and lift up on the rear of the wireless charging module bracket (1).
  5. Slide the bracket (1) toward the rear of the vehicle to release it from the front of the floor console.
  6. Disconnect the wire harness connector (3) from the wireless charging pad module.
    GC0202782Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fasteners (1) from the wireless charging module (2) and remove it from the wireless charging module bracket (3).
scientia non olet · About LEMON Manuals