Removal And Installation: Removal

Open the cover of the fuse box in the engine compartment and remove the fuse F21 (15 A) of the fuel pump.
Start the engine and run until the fuel in the lines is depleted.
Install the fuse removed earlier and close the fuse box cover.
Remove the rear seat cushion. Refer to SEAT CUSHION, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Lift the cover, unscrew the screws and remove the cover (1) to access the fuel pipes.

Courtesy of CHRYSLER GROUP, LLC
Open the clamp (1) and release the fuel vapor hoses.

Courtesy of CHRYSLER GROUP, LLC
Lift the cover, unscrew the screws and remove the cover to access the fuel pump.

Courtesy of CHRYSLER GROUP, LLC
Unplug the wire harness connector (1) from fuel pump.
Disconnect the fuel delivery pipe quick coupling (2).
Disconnect the fuel vapor pipe quick couplings (3).

Courtesy of CHRYSLER GROUP, LLC
Mount the 2000002100 (EMEA) or (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (NAFTA) tool (1a) and remove the pump assembly mounting ring set (1b).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the quick coupling of the fuel vapor recovery pipe (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump assembly (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the seal on the tank (1).