Removal And Installation: Installation
- Install a new O-ring, supplied with the new capless fuel fill receptacle.NOTE:
Make sure that the O-ring is properly positioned in the throat of the fuel fill tube.
- Place in its seat the new capless fuel fill receptacle aligning the groove with the tooth of the fuel fill tube.
- Place the ring (1a) of the installation tool (2000039800) so that the screws (1b) coincide with the four fastening clips of the capless fuel fill receptacle.
- Prepare the installation tool (2000042900) (1a) and (1b) as shown in illustration.
- Position the tools (1a) and (1b) as shown in illustration.
- Check that the jaws have engaged the ring and the collar "a" of the fuel fill tube.
- Tighten the screw (1a) to engage the capless fuel fill receptacle (1b) on the collar of the fuel fill tube.
- Unscrew the screws and remove the driver shown in illustration (1).
- Tighten the screws into the rings to crush the four fasteners.
- Remove the tools and verify that the four pegs of the capless fuel fill receptacle are properly installed.
- Install the fuel fill door, engaging the retaining clips.
- Install the fuel door retaining device and rotate the screw 90°.