LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Trailhawk >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Fan, Cooling >> Removal And Installation >> 2.4L Multi Air >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

2.4L Multi Air: Removal

GC0164856Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the bolts (1a) and nuts (1b) and the exhaust heat shield (1c).
  3. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
    GC0164459Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    When removing the transmission oil cooler line on the 2.4L Multi Air engine, use Special Tool 8875A with the fingers of the tool facing the quick connect fitting.

  4. Do not remove the retaining clips (1a), install Special Tool 8875A or equivalent over the quick connect fitting and disconnect the transmission oil cooler line (1b).
  5. Plug and seal the ends of the transmission cooler lines and lines disconnected, to prevent leakage of oil or moisture, contaminates, or impurities entering into the system.
    GC0165116Courtesy of CHRYSLER GROUP, LLC
  6. Remove the fasteners (1a) and the pressurized coolant bottle (1b).
    GC0165167Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the resistor wire harness connector (1a).
  8. Disconnect the cooling fan wire harness connector (1b).
  9. Detach the wire harness retainer (1c) from fan shroud.
  10. Open the retainer (2b) detach the cooler lines from retainer.
    GC0164846Courtesy of CHRYSLER GROUP, LLC
  11. Remove the cooling fan bolts (1) and remove the cooling fan.
scientia non olet · About LEMON Manuals