Diagnostic Test

CHECK FOR POWERTRAIN CONTROL MODULE (PCM) DTCS
1. With the scan tool, read PCM DTCs.
  Are there any other PCM DTCs present?
  
  Yes
  - Perform the applicable diagnostic procedure(s) for the other PCM DTC(s). Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 2
CHECK FOR ANY SERVICE BULLETINS OR PCM SOFTWARE UPDATES
1. Check for any applicable Service Bulletins, Star On-line Cases or Flash updates related to the DTC or stall condition.
  Are there any applicable Service Bulletins, Star On-line Cases or Flash updates?
  
  Yes
  - Perform the applicable repair.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Perform the START AND STALL CONDITION test procedure. Refer to DRIVEABILITY, NON-DTC BASED DIAGNOSTICS . The START AND STALL CONDITION test procedure lists several possible causes for a stall condition. This is a general list to help give direction where to look for an issue that can cause a stall. If the vehicle is setting this DTC alone with no other faults do not overlook possible intermittent circuit issues for any component or system that can cause an engine to intermittently stall. An intermittent stall event is most likely not going to be caused by an engine mechanical part issue affecting the engine combustion. Focus on electrical issues for components that can affect spark or fueling and perform the INTERMITTENT CONDITION test procedure. Refer to INTERMITTENT CONDITION .