Installation

NOTE: For models with drum type rear brakes, refer to Drum Brake System.

1. Position mounting support on rear wheel spindle and install two mounting support bolts.

Tightening torque: 33 - 49 ft. lbs. (45 - 67 Nm)

2. Insert guide plate in mounting support.
3. Install disc pads and shim out of disc plate, and secure disc pads with V-springs.





4. Turn in brake caliper piston by using Special Service Tool (SST) 0K9A4 263 001 or equivalent, to insert disc pads into brake caliper.
5. Tighten two brake caliper lock bolts.

Tightening torque: 22 - 29 ft. lbs. (29 - 39 Nm)

6. Connect brake hose with caliper and install connecting bolt.

Tightening torque: 16 - 22 ft. lbs. (22 - 29 Nm)

7. Install parking cable in clip and caliper.
8. Bleed brakes.