Abs/TCS (Anti-Lock Brake System & Traction Control)
- General
- Anti-Lock Brake System (Abs)
- System Component
- Terminal Voltage Chart
- Bleeding Brake System
- Standard Flow Of Diagnostic Troubleshooting
- Abs Check Sheet
- Hi-Scan Check
- Abs & TCS Warning Lamp Inspection
- Inspection Procedure Chart For Trouble Symptoms
- Inspection Procedures For Trouble Symptoms
- INSPECTION PROCEDURE 1: Communication With Hi-Scan Is Not Possible (Communication With All Systems Is Not Possible)
- INSPECTION PROCEDURE 2: Communication With Hi-Scan Is Not Possible (Communication With Only ABS System Is Not Possible)
- INSPECTION PROCEDURE 3: When Ignition Key Is Turned To ON (Engine Stopped), ABS Warning Lamp Does Not Illuminate
- INSPECTION PROCEDURE 4: Even After The Engine Is Started, The ABS Warning Lamp Remains Illuminated
- INSPECTION PROCEDURE 5: Brake Operation Is Abnormal
- Wheel Speed Sensor Output Voltage Check
- Inspection Procedure Chart For Diagnostic Trouble Codes
- Inspection Procedures For Diagnostic Trouble Codes
- DTC C1200, DTC C1203, DTC C1206, Or DTC C1209: WHEEL SPEED SENSOR OPEN OR SHORT TO GND CIRCUIT
- DTC C1201, DTC C1204, DTC C1207, Or DTC C1210: SPEED JUMP OR WRONG EXCITER
- DTC C1245: Wheel Speed Sensor Frequency Error
- DTC C1103: Voltage Out Of Range (Under And Over Voltage)
- DTC C1604: Hydraulic And Electronic Control Unit (HECU) Hardware (Error Valve Failure)
- DTC C2112: Valve Relay (Including Fuse Failure)
- DTC C1605/DTC C2114: Can Hardware Error/Disturbance
- DTC C1611: Engine Management System (Ems) Error
- DTC C2402: Electrical (Pump-Motor)
- DTC C1161: Brake Light Switch
- DTC: Abs, EBD And TCS Warning Lamp
- DTC: TCS Off Switch
- System Function Diagram
- Anti-Lock Braking System Control Module
- Wheel Speed Sensor
- Traction Control System (TCS)
- Electronic Brake-Force Distribution (EBD)