Component Inspection

1. Specification:
   Fig 1: Measuring Resistance Between Terminals 1 And 3 Of Sensor Connector (Component Side)

   
   RESISTANCE REFERENCE CHART
   
   

   Temp. (°C)	Temp. (°F)	Resistance (kΩ)
   -20	-4	13.24~16.83
   20	68	2.27~2.64
   80	176	0.207~0.429

YES

1. Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO

1. Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.