Monitor Scantool Data

Ignition "ON" & Engine "OFF"
Connect Scantool and monitor the "TPS VOLTAGE" parameter on scantool.
1. Specification:
1. Throttle valve fully closed: Approx. 0.2~0.8V
2. Throttle valve fully open: Approx. 4.0~4.4V
3. TP sensor signal should increase smoothly as throttle is opened.
  
  Fig 1: Display Signal Increases Proportionally With Throttle Opening Angle
  
  Fig 2: Display TPS Data
  
  Fig 3: Display TPS Data (Signal Circuit Open)
  
  Fig 4: Display TPS Data (Power Supply Circuit Open)
Is TPS parameter near the specified value?
YES
1. Fault is intermittent caused by poor contact in the sensor's and/or the ECM's connector, which was repaired but ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
1. Go to "W/HARNESS INSPECTION " procedure.