LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Magentis 2.4 3 >> Repair and Diagnosis >> Restraints >> Seat Belts >> SRS Control Module >> SRS Control Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

SRS Control Module: Installation

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the SRSCM with the SRSCM mounting nuts.

    Tightening torque (SRSCM Mounting nut)

    : 1.0-1.4 kgf.m (10.2-13.8 N.m, 7.5-10.2 lb.ft)

    NOTE: Use new mounting nuts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
  5. Install the heater ducts and floor console. (Refer to INTERIOR )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals