Ground Circuit Inspection

Ignition "ON" & Engine "OFF".
Disconnect the "OUTPUT SPEED SENSOR" connector.
Measure resistance between terminal "1" of the OUTPUT SPEED SENSOR harness connector and chassis ground.
Specification: approx. 0 Ω

Fig 1: Identifying Output Speed Sensor And Sensor Ground
Courtesy of KIA MOTORS AMERICA, INC.
Is resistance within specification?
YES : --> Go to "COMPONENT INSPECTION " procedure.

no : --> Check for open in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

--> If ground circuit in harness is OK, Go to 2 "Check TCM (PCM)" of the "Component Inspection" procedure.