LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Automatic >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control System >> Side Impact Sensor (Sis) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Side Impact Sensor (Sis): Installation

CAUTION:
  • Be sure to install the harness wires not to be pinched or interfered with other parts.
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

    Tightening torque

    1.0~1.4 kgf.m (9.5~13.5 Nm, 7.0~10.0 lb.ft)

  2. Install the center piller trim. (Refer to INTERIOR )
  3. Install the front seat assembly. (Refer to SEATS )
  4. Reconnect the negative battery cable.
  5. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals