3. Terminal Input/Output Signal (Connector CBG-K)
CONNECTOR TERMINAL INPUT/OUTPUT SIGNAL REFERENCE
| Pin No. | Description | Condition | Type | Level | Test Result |
|---|---|---|---|---|---|
| 1 | Power Ground | Idle | DC | Max. 50mV | - |
| 2 | Battery voltage supply after ignition switch | IG OFF | DC | Max. 1.0V | 1.18 mV |
| IG ON | Battery Voltage | 12.7V | |||
| 3 | Power Ground | Idle | DC | Max. 50mV | -4.37 mV |
| 4 | Battery voltage supply after main relay | IG OFF | DC | Max. 1.0V | -5.1 mV |
| IG ON | Battery Voltage | 12.3V | |||
| 5 | ECM Ground | Idle | DC | Max. 50 mV | 10.1 mV |
| 6 | Battery Power | Always | DC | Battery Voltage | 12.2V |
| 7 | Ignition Coil (Cylinder #1,4) control output | Idle | Pulse | 1st Voltage: 300 ~ 400V | 372V |
| ON Voltage: Max. 2.0V | 1.6V | ||||
| 8 | Shield | Idle | DC | Max. 50mV | 18.3 mV |
| 9 | Sensor ground | Idle | DC | Max. 50 mV | 18.7 mV |
| 10 | Mass Air Flow Sensor signal input | Idle | DC | 0 ~ 2.0V | 1.1V |
| 3,000 RPM | 1.0 ~ 4.5V | 1.85V | |||
| 11 | - | - | - | - | - |
| 12 | Ground | Idle | DC | Max. 50mV | - |
| 13 | A/C Pressure Transducer signal input | Idle | DC | 0.4 ~ 4.6V | A/C OFF: 1.18\A/C ON:1.48V |
| 14 | Sensor ground | Idle | DC | Max. 50mV | 13.0 mV |
| 15 | Engine Coolant Temperature Sensor signal input | Idle | DC | 0.5 ~ 4.5V | 1.84V |
| 16 | Sensor ground | Idle | DC | Max. 50mV | - |
| 17 | - | - | - | - | - |
| 18 | - | - | - | - | - |
| 19 | - | - | - | - | - |
| 20 | - | - | - | - | - |
| 21 | Sensor ground | Idle | DC | Max. 50mV | - |
| 22 | Knock Sensor signal input | Knocking | Variable Frequency | - | - |
| Normal | - | - | |||
| 23 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V | 0V |
| IG ON | 4.9 ~ 5.1V | 5.03V | |||
| 24 | - | - | - | - | - |
| 25 | Injector (Cylinder #1) control output | Idle | DC | Hi: Battery Voltage | 14.4V |
| Lo: Max. 1.0V | 280 mV | ||||
| Vpeak: Max. 80V | 48.8V | ||||
| 26 | Injector (Cylinder #3) control output | Idle | DC | Hi: Battery Voltage | 14.2V |
| Lo: Max. 1.0V | 240 mV | ||||
| Vpeak: Max. 80V | 49.0V | ||||
| 27 | Injector (Cylinder #4) control output | Idle | DC | Hi: Battery Voltage | 14.4V |
| Lo: Max. 1.0V | 280 mV | ||||
| Vpeak: Max. 80V | 48.8V | ||||
| 28 | Injector (Cylinder #2) control output | Idle | DC | Hi: Battery Voltage | 14.2V |
| Lo: Max. 1.0V | 240 mV | ||||
| Vpeak: Max. 80V | 49.0V | ||||
| 29 | Ignition Coil (Cylinder #2,3) control output | Idle | Pulse | 1st Voltage: 300 ~ 400V | 376V |
| ON Voltage: Max. 2.0V | 1.36V | ||||
| 30 | - | - | - | - | - |
| 31 | - | - | - | - | - |
| 32 | - | - | - | - | - |
| 33 | Fuel Tank Pressure Sensor signal input | Idle | DC | 0.4 ~ 4.6V | 2.58V |
| 34 | Sensor ground | Idle | DC | Max. 50mV | 16.1 mV |
| 35 | - | - | - | - | - |
| 36 | - | - | - | - | - |
| 37 | Sensor ground | Idle | DC | Max. 50mV | 17.3 mV |
| 38 | Heated Oxygen Sensor (B1/S2) signal input | Racing | Analog | Rich: 0.6 ~ 1.0V | 640 mV |
| Lean: Max. 0.4V | 22 mV | ||||
| 39 | Sensor ground | Idle | DC | Max. 50mV | 3.14 mV |
| 40 | CVVT Oil Temperature Sensor signal input | Idle | Analog | 0.5 ~ 4.5V | 950 mV |
| 41 | Throttle Position Sensor signal input | C.T | Analog | 0.25 ~ 0.9V | 307 mV |
| W.O.T | Min. 4.0V | 4.28V | |||
| 42 | Sensor ground | Idle | DC | Max. 50mV | 13.6 mV |
| 43 | VS+ (NERNST Cell Voltage) | Engine Run | Analog | Normal: 450±50 mV | 440 mV |
| Rich: Max. Normal+150 mV | 508 mV | ||||
| Lean: Min. Normal-150 mV | 356 mV | ||||
| 44 | VS-/IP- (Common Ground for VS.IP) | Engine Run | Analog | Reference for VS.IP | Hi: 2.7V Lo: 2.0V |
| 45 | Rc/Rp (Pump Cell Voltage) | Engine Run | Analog | Normal: 0±500 mV | 440 mV |
| Rich: Min. Normal-1.5 mV | -860 mV | ||||
| Lean: Max. Normal+1.5 mV | 870 mV | ||||
| 46 | Re (Compensative Resistance) | Idle | Analog | | Rc-Rc/Rp | <±0.1V0|LH | -107 mV |
| 47 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V | 2.61 mV |
| IG ON | 4.9 ~ 5.1V | 5.04V | |||
| 48 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V | 3.16 mV |
| IG ON | 4.9 ~ 5.1V | 5.06V | |||
| 49 | - | - | - | - | - |
| 50 | - | - | - | - | - |
| 51 | - | - | - | - | - |
| 52 | - | - | - | - | - |
| 53 | Vehicle speed signal input | Vehicle Run | Pulse | Hi: Min. 4.5V | 13.0V |
| Lo: Max. 0.5V | -200 mV | ||||
| 54 | - | - | - | - | - |
| 55 | Wheel Speed Sensor [A] signal input | Vehicle Run (30 km/h) | SINE Wave | 15 Hz: Min. 0.13Vpp | - |
| 1,000 Hz: Min 0.2Vpp | - | ||||
| Overall: Max. 250Vpp | - | ||||
| 56 | Wheel Speed Sensor [B] signal input | Vehicle Run (30 km/h) | SINE Wave | 15 Hz: Min. 0.13Vpp | - |
| 1,000 Hz: Min 0.2Vpp | - | ||||
| Overall: Max. 250Vpp | - | ||||
| 57 | Sensor ground | Idle | DC | Max. 50mV | 10 mV |
| 58 | - | - | - | - | - |
| 59 | - | - | - | - | - |
| 60 | A/C switch "ON" signal input | A/C S/W OFF | DC | Max. 1.0V | 0 mV |
| A/C S/W ON | Battery Voltage | 12.8V | |||
| 61 | - | - | - | - | - |
| 62 | A/C thermal switch signal input | A/C S/W OFF | DC | Max. 1.0V | 0 mV |
| A/C S/W ON | Battery Voltage | 12.8V | |||
| 63 | Fuel consumption signal output | Idle | Pulse | Hi: Battery Voltage | 13.8V |
| Lo: Max. 0.5V | 0.1V | ||||
| 64 | Main Relay control output | Relay OFF | DC | Battery Voltage | 12.9V |
| Relay ON | Max. 1.0V | 0.88V | |||
| 65 | Cooling Fan Relay [Low] control output | Relay OFF | DC | Battery Voltage | 12.9V |
| Relay ON | Max. 1.0V | 30 mV | |||
| 66 | CVVT Oil Control Valve control output | Idle | Pulse | Battery Voltage | 14.8V |
| Max. 1.0V | 100 mV | ||||
| 67 | Purge Control Solenoid Valve control output | Active Inactive | Pulse | Hi: Battery Voltage | 14.2V |
| Lo: Max. 1.0V | 100 mV | ||||
| 68 | - | - | - | - | - |
| 69 | Immobilizer lamp control output | Lamp OFF | DC | Battery Voltage | - |
| Lamp ON | Max. 2.0V | - | |||
| 70 | Fuel Pump Relay control output | Relay OFF | DC | Battery Voltage | 13V |
| Relay ON | Max. 1.0V | 100 mV | |||
| 71 | - | - | - | - | - |
| 72 | - | - | - | - | - |
| 73 | Battery voltage supply after main relay | IG OFF | DC | Max. 1.0V | -5.1 mV |
| IG ON | Battery Voltage | 12.3V | |||
| 74 | Alternator load signal input | Idle | Pulse | Hi: Battery Voltage | 14V |
| Lo: Max. 1.5V | 10 mV | ||||
| 75 | Immobilizer communication line | When communicating after IG ON | Pulse | Hi: Min. 8.5V | - |
| Lo: Max. 3.5V | - | ||||
| 76 | - | - | - | - | - |
| 77 | CAN [HIGH] | RECESSIVE | Pulse | 2.0 ~ 3.0V | 2.55V |
| DOMINANT | 2.75 ~ 4.5V | 3.57V | |||
| 78 | CAN [LOW] | RECESSIVE | Pulse | 2.0 ~ 3.0V | 2.55V |
| DOMINANT | 0.5 ~ 2.25V | 1.44V | |||
| 79 | Sensor ground | Idle | DC | Max. 50mV | 10 mV |
| 80 | Camshaft Position Sensor signal input | Idle | Pulse | Hi: Vcc | 5.0V |
| Lo: Max. 0.5V | 0.2V | ||||
| 81 | Sensor ground | Idle | DC | Max. 50mV | 10 mV |
| 82 | Crankshaft Position Sensor signal input | Idle | Pulse | Hi: Vcc | 5.0V |
| Lo: Max. 0.5V | 40 mV | ||||
| 83 | - | - | - | - | - |
| 84 | Clutch Switch signal input | Release | DC | Max. 0.5V | - |
| Push | Battery Voltage | - | |||
| 85 | - | - | - | - | - |
| 86 | Engine speed signal output | Idle | Pulse | Hi: Battery Voltage | 14.0V |
| Lo: Max. 0.5V | 100 mV | ||||
| Freq.: 20 ~ 26 Hz | 21.8 Hz | ||||
| 87 | A/C Compressor Relay control output | Relay OFF | DC | Battery Voltage | 14.1V |
| Relay ON | Max. 1.0V | 0.1V | |||
| 88 | Cooling Fan Relay [High] control output | Relay OFF | DC | Battery Voltage | 14.1V |
| Relay ON | Max. 1.0V | 320 mV | |||
| 89 | Idle Speed Control Actuator [OPEN] control output | Idle | Pulse | Hi: Battery Voltage | 14.6V |
| Lo: Max. 1.0V | 192 mV | ||||
| 90 | Idle Speed Control Actuator [CLOSE] control output | Idle | Pulse | Hi: Battery Voltage | 14.9V |
| Lo: Max. 1.0V | 248 mV | ||||
| 91 | Canister Close Valve control output | Active Inactive | Pulse | Hi: Battery Voltage Lo: Max. 1.0V | 14.0V 170 mV |
| 92 | Malfunction Indicator Lamp (MIL) control output | Lamp OFF | DC | Battery Voltage | 13V |
| Lamp ON | Max. 1.0V | 50mV | |||
| 93 | Heated Oxygen Sensor (B1/S1) Heater control output | Engine Run | Pulse | Hi: Battery Voltage | 14V |
| Lo: Max. 1.0V | 0.3V | ||||
| 94 | Heated Oxygen Sensor (B1/S2) Heater control output | Engine Run | Pulse | Hi: Battery Voltage | 14V |
| Lo: Max. 1.0V | 0.3V |