Monitor Scan Tool Data

Ignition "ON" & Engine "OFF".
Connect Scan tool and clear the DTCs.

Fig 1: Scan Tool Display - P1610 Non Immobilizer ECU
Courtesy of KIA MOTORS AMERICA, INC.
Is the DTC "P1610 Non Immobilizer ECU" displayed?
YES

Replace ECM which has a Immobilizer system and perform key teaching.

And then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO

Fault is intermittent caused by poor contact in the SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.