Signal Circuit Inspection

Check open in harness.
1. IG "OFF".
2. Disconnect MAFS and ECM/PCM connector.
3. Measure resistance between terminal 3 of MAFS harness connector and terminal 10/C01-1 of ECM/PCM harness connector. [A/T]
  Measure resistance between terminal 3 of MAFS harness connector and terminal 19/C01 of ECM/PCM harness connector. [M/T]
  
  Specification: Below 1Ω
4. Is the measured resistance within specification?
  YES
  - Go to 2 "Check short to ground in harness" as follows.
  NO
  - Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check short to ground in harness.
1. IG "OFF".
2. Disconnect MAFS and ECM/PCM connector.
3. Measure resistance between terminal 3 and 4 of MAFS harness connector.
  Specification: Infinite
4. Is the measured resistance within specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.