LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2008 >> Sedona Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control System >> Front Impact Sensor (FIS) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Impact Sensor (FIS): Installation

CAUTION:
  • Ensure that the harness is installed and routed properly to prevent damage to the wiring.
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Install the new Front Impact Sensor with bolt then connect the SRS harness connector to the Front Impact Sensor.

    Tightening torque:

    1.0-1.4 kgf.m (9.5-13.6 N.m, 7.0-10.0 lb.ft)

  2. Reconnect the negative battery cable.
  3. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals