LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Rio Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Troubleshooting >> DTC P0708 Transaxle Range Switch-Multi-Input >> Power Supply Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Supply Circuit Inspection

  1. Disconnect TRANSAXLE RANGE SWITCH" connector.
  2. Ignition "ON" & Engine "OFF".
  3. Measure voltage between each terminal of the sensor harness connector and chassis ground.

    Specification: Shown below

    CONNECTOR TERMINAL SPECIFICATIONS

    TERMINAL (C11) 2 3 4 5 6 7 8 9 10 11 12
    SPECIFICATION 0V 12V 0V 0V 12V 0V 0V 0V 0V 0V 0V
    Fig 1: Measuring Voltage Between Terminal Of Sensor Harness Connector
    G04862538Courtesy of KIA MOTORS AMERICA, INC.
  4. Is voltage within specifications?

    YES  : --> Go to "SIGNAL CIRCUIT INSPECTION " procedure.

    NO  : --> Check for short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals