Repair procedures: Installation
- Disconnect the negative (-) cable from battery and wait for at least three minutes.
- Remove ignition key from the vehicle.
- Install the SRSCM with the SRSCM mounting bolt and nuts.
Tightening Torque : 1.0 ~ 1.4 kgf.m (9.5 ~ 13.6 Nm, 7.0 ~ 10.0 lb.ft)
- Connect the SRSCM harness connector.
- Install the heater ducts and floor console. (Refer to INTERIOR )
- Connect the DAB, PAB, SAB, CAB and BPT connectors.
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.