LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Soul Base >> Repair and Diagnosis >> Restraints >> Seat Belts >> SRS Control Module >> SRS Control Module (SRSCM) >> Components and Component Locations >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Components and Component Locations: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening torque (SRSCM Mounting Bolt): 

    7.8 ~ 9.8 Nm (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb.ft)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM connectors (A) and (B) by pushing the lever (3) and lock (1) completely.
    NOTE: When installing the airbag wiring harness, ground points (C) must be installed.
    Fig 1: Identifying SRSCM Connectors, Lever, Lock, & Ground Points
    G06524839Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the floor console. (Refer to CONSOLE )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON. The SRS indicator light should be illuminated for about six seconds and then turn off.
scientia non olet · About LEMON Manuals