Throttle Position Sensor (TPS)

1. Connect GDS on the Data Link Connector (DLC).
2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
   VOLTAGE SPECIFICATION
   
   

   Throttle Angle	Output Voltage (V)
   	TPS 1	TPS 2
   C.T	0.25 ~ 0.9	Min.4.0
   W.O.T	Min.4.0	0.25 ~ 0.9

3. Turn the ignition switch OFF and disconnect the GDS from the DLC.
4. Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 4.

Specification:  Refer to SPECIFICATION .