Repair procedures: Inspection

1. Turn ignition switch OFF.
2. Disconnect the VCMA connector.
3. Check that the VCMA is not stuck by foreign material.
4. Measure resistance between motor (+) and (-) control terminals of the motor.
5. Check that the resistance is within the specification.

   Specification: 

   (Normal) 1 ~ 999 Ω

   (Short circuit) Below 1 Ω

   (Open circuit) Over 1 kΩ

6. Measure resistance between voltage supply terminal and ground terminal of the position sensor.
7. Check that the resistance is within the specification.

Specification:  3.44 ~ 5.16 (20°C (68°F))