Fuel Tank Pressure Sensor: Service and Repair

Inspection

1. Connect the GDS on the Data Link Connector (DLC).
2. Measure the output voltage of the FTPS.

Specification:Refer to "Specification"

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the fuel pump service cover (A) in the trunk.




3. Disconnect the fuel tank pressure sensor connector (A), and then remove the fuel tank pressure sensor.






Installation

CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

CAUTION:
- Insert the sensor in the installation hole and be careful not to damage.

1. Installation is reverse of removal.