Repair Procedures: Installation
CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
- DON'T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
- Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
- Installation is reverse of removal.
Heated oxygen sensor installation (Bank 1/Sensor 1):
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated oxygen sensor installation (Bank 1/Sensor 2):
35 ~ 45 N.m (3.6 ~ 4.6 kgf.m, 25.8 ~ 33.2 lb-ft)