Sunvisor Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
- Remove the following items:
- Front seat
(Refer to the "FRONT SEAT ")
- Rear seat
(Refer to the "REAR SEAT ")
- Front pillar trim
(Refer to the "INTERIOR TRIM ")
- Front door scuff trim & Rear door scuff trim
(Refer to the "INTERIOR TRIM ")
- Center pillar lower trim & Center pillar upper trim
(Refer to the "INTERIOR TRIM ")
- Luggage side trim
(Refer to the "INTERIOR TRIM ")
- Rear pillar trim
(Refer to the "INTERIOR TRIM ")
- Front seat
- Remove the sunvisor
- Remove the sunvisor (A) and holder (B) from each side.
- Remove the assist handle
- Remove the covers (B), and remove the screws, then remove the assist handle (A).
- Remove the overhead console.
- Remove the cover (A).
- After loosening the overhead console mounting screws, remove the overhead console lamp (A).
- Disconnect the connector (B).
- Remove the room lamp.
- Remove the room lamp cover (A).
- Remove the screws.
- Pull out the room lamp (A).
- Disconnect the connector (B).
- After loosening the mounting screws, remove the sunglass case (A).
- Disconnect the connector (B).
[Driver's]
- Disconnect the connector (A).
[Passenger's]
- Disconnect the sunroof motor connector (B).
- Remove the roof trim (A).
- Installation is the reverse of removal.NOTE:
- Replace any damage clips.
- Make sure the connector is plugged in properly.