Repair procedures: Installation
NOTE:
When replacing the ECM, the vehicle equipped with the smart key must be performed the procedure below.
Then the ECM key register process is completed automatically.
Then the ECM key register process is completed automatically.
[In the case of installing used ECM]
- Perform "Neutral mode" procedure with GDS. (Refer to "NEUTRALIZATION STATUS CHECK " )
- Turn the ignition ON and OFF position after completing "ECM neutral mode".
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
- Turn the ignition ON and OFF position after completing "ECM neutral mode".
Then the ECM key register process is completed automatically.
NOTE:
ECM is combined with TCM. Therefore perform the necessary procedures after replacing or reinstalling a ECM. (Refer to TCM LEARNING
)
- Installation is reverse of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
ECM bracket installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)