Repair Procedures: Installation

Install in the reverse order of removal.
NOTE:
- When installing, set control shaft lever to neutral position.
  
  Fig 1: Control Shaft Lever Neutral Position
  Courtesy of KIA MOTORS AMERICA, INC.
- When installing, apply the sealant as shown in the illustration.
  Specified sealant: LOCTITE 5060 or Anaerobic adhesives type J (For flange)
Fig 2: Control Shaft Lever Sealant Application Part
Courtesy of KIA MOTORS AMERICA, INC.
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.