Repair Procedures: Installation

NOTE:

Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair Procedures ")
When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as shownbelow.
[In the case of installing used TCM]
1. Perform TCM Neutral mode procedure with GDS".
  (Refer to IMMOBILIZER SYSTEM
2. After finishing "TCM Neutral mode", perform Key teaching procedure with GDS". .
  (Refer to IMMOBILIZER SYSTEM
[In the case of installing new TCM]

Perform "Teaching procedure with GDS".

(Refer to IMMOBILIZER SYSTEM
When replacing the TCM, the vehicle equipped with the smart key system (Button start) must be performed procedure as shown below.
[In the case of installing used TCM]
1. Perform "Neutral mode procedure with GDS".
  (Refer to IMMOBILIZER SYSTEM
2. After finishing "TCM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the TCM learns the smart key information automatically.
  [In the case of installing new TCM]
  
  Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the TCM learns the smart key information automatically.