Repair Procedures: Adjustment

After replacing the ECM of the vehicle with the Immobilizer / Smart Key System, the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
  [If installing a new ECM]
  
  Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
After replacing the ECM of the vehicle with the SMART KEY SYSTEM (button start), the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
2. After finishing "ECM Neutral Mode", turn IGN ON then OFF using the Smart Key or Start Button. Then the ECM learns information on the Smart Key automatically.
  [If installing a new ECM]
  
  Turn IGN ON then OFF using the Smart Key or Start Button. Then the ECM learns information on the Smart Key automatically.