Repair Procedures: Removal

Open the trunk.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the floor mat in the trunk (Refer to Body - "TRUNK TRIM ").
Remove the Partition board trim (A).

Fig 1: Removing Partition Board Trim
Courtesy of KIA MOTORS AMERICA, INC.
Remove the service cover (A) in the trunk.

Fig 2: Removing Service Cover Into Trunk
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the fuel tank pressure sensor connector (A).
Remove the fuel tank pressure sensor after removing the mounting bolt.

Fig 3: Disconnecting Fuel Tank Pressure Sensor Connector

Courtesy of KIA MOTORS AMERICA, INC.