Blind Spot Detection System DTCS
BLIND SPOT DETECTION SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101 | 17: Battery Voltage High |
| DTC C1102 | 16: Battery Voltage Low |
| DTC C1283 | 81: Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error |
| DTC C1501 | 01: Switch Failure |
| DTC C160A | 88: BSD Local CAN Bus OFF |
| DTC C1611 | 87: CAN Time-Out EMS |
| DTC C1612 | 87: CAN Time-Out TCU |
| DTC C1613 | 81: CAN signal error EMS |
| DTC C1616 | 88: CAN Bus OFF (C-CAN) |
| DTC C1625 | 87: CAN Time-Out ABS/ESC (ESP) |
| DTC C1628 | 87: CAN Time-Out Cluster |
| DTC C1646 | 81: CAN Message Failure - TCU |
| DTC C1702 | 55: Variant Coding Error |
| DTC C170A | 11: Activation Switch LED Circuit short to ground |
| DTC C170B | 12: Activation Switch LED Circuit short to battery or open |
| DTC C170C | 04: ECU Hardware error (REAR RIGHT) |
| DTC C170D | 04: ECU Hardware error (REAR LEFT) |
| DTC C1743 | 05: Software Mis-Match |
| DTC C2702 | 54: Control Module Master Missing Calibration |
| DTC C2703 | 54: Control Module Slave Missing Calibration |