Repair Procedure: Removal

WARNING:

DO NOT remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake]

Fig 1: Locate Camshaft Position Sensor Connector (Bank 1/Intake)

Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Exhaust]

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the camshaft position sensor connector (A).
Remove the engine hanger & camshaft position sensor protector after loosening the mounting bolt (B).
Remove the mounting bolt (C), and then remove the sensor.

Fig 2: Locate Camshaft Position Sensor Connector (Bank 1/Exhaust)

Courtesy of KIA MOTORS AMERICA, INC.

NOTE: When installing the sensor connector be sure to keep the wiring clip position (A).

Fig 3: Locate Wiring Clip Piston

Courtesy of KIA MOTORS AMERICA, INC.