Repair Procedures: Removal

Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ").
Drain the coolant.
(Refer to Engine Mechanical System - "COOLANT ")
Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.
Tightening Torque:

33.3 - 43.1 N.m (3.4 - 4.4 kgf.m, 24.6 - 31.8 lb.ft)

Fig 1: Locate ATF Drain Plug
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: The existing ATF drain plug gasket must be replaced with new one. (Do not reuse it.)
Remove the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the wiring bracket mounting bolt (A)
Tightening Torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 2: Locate Wiring Bracket Mounting Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the air breather hose (A) from the valve body cover.

Fig 3: Locate Valve Body Cover Air Breather Hose
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the coolant pip (B) after removing the clamp (A).

Fig 4: Locate Coolant Pipe And Clamp
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the ATF cooler hose (B) after removing the clamp (A).

Fig 5: Locate ATF Cooler Hose And Clamp
Courtesy of KIA MOTORS AMERICA, INC.
Remove the valve body cover (A).

Fig 6: Locate Valve Body Cover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the solenoid valve harness (A) and oil temperature sensor (B) after removing the bolts.
Tightening Torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 7: Locate Solenoid Valve Harness And Oil Temperature Sensor
Courtesy of KIA MOTORS AMERICA, INC.
Remove solenoid valve support bracket (A).
Tightening Torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 8: Locate Solenoid Valve Support Bracket
Courtesy of KIA MOTORS AMERICA, INC.
Remove the overdrive clutch control solenoid valve (A).

Fig 9: Locate Overdrive Clutch Control Solenoid Valve

Courtesy of KIA MOTORS AMERICA, INC.