Repair Procedures: Removal

CAUTION:

NOTE:

Remove both sides of the front pillar trim.
(Refer to "FRONT PILLAR TRIM .")
Remove both sides of the A pillar garnish.
(Refer to "A PILLAR GARNISH .")
Remove the cowl top cover.
(Refer to "COWL TOP COVER .")
Remove the inside rear view mirror assembly.
(Refer to "INSIDE REAR VIEW MIRROR .")
Remove the LDWS unit.
(Refer to "LANE DEPARTURE WARNING SYSTEM (LDWS) UNIT .")
Cut out the adhesive using a cutter (A).
Information
- Please use a cutter with a blade length between 8-12 inches.
Courtesy of
Cut off the sealant on the edge (B) while pulling the piano wire (A) left and right.

Courtesy of
If a piano wire is visible inside the chassis, pull the piano wire (A) line inside.

Courtesy of
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Courtesy of
Remove the windshield glass (B) carefully using the glass holder (A).

Courtesy of