Repair Procedures: Installation

Check that the shift lever is placed in the "N" position
Install the inhibitor switch (A).
NOTE: Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.

Courtesy of
Install the manual control lever (A).
NOTE: Lightly tighten the manual control lever nut (B) so that necessary adjustments can be made.

Courtesy of
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).

Courtesy of
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque:

A: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

B: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Courtesy of
Remove the SST (09480-A3800) from the hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
NOTE: Lightly tighten the shift cable mounting nut (B) so that necessary adjustments can be made.

Courtesy of
Push the shift cable to the arrow "F" to eliminate free play and then tighten the nut (A) with the specified torque.
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

Courtesy of
Install the air cleaner assembly.
(Refer to "AIR CLEANER .")
Connect the battery negative (-) cable.