Repair Procedures: Installation

NOTE: When installing, set room side shift lever and T/M side lever to "4th" gear position.

Tighten the nut (B) after install the retainer (A).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Courtesy of
Check the Shift lever is in "4th" gear position.
Install the cable socket (A) on the shift lever assembly.

Courtesy of
Install the shift cable (B) after installing the clip (A).

Courtesy of
Install the select cable socket (C) on the shift lever assembly.
Install the clip (A) after installing the select cable (B).

Courtesy of
Install the bracket (A).

Courtesy of
Install the rear heating joint duct (A).
Install the floor console assembly.
(Refer to "FLOOR CONSOLE .")
Rotating clockwise shift lever knob (A).

Courtesy of
Install the control cable (B) and clip (A) on the bracket.
NOTE: Do not reuse the clip (A).

Courtesy of
Install the control cable
1. Install the control cable (A) in transaxle lever pin.
  
  Courtesy of
2. Ensure to press adjust locking button in direction of "C".
  
  Courtesy of
3. Install the washer (A) and pin (B).
  
  Courtesy of
Install the battery and battery tray.
(Refer to "BATTERY .")
Install the air cleaner assembly.
(Refer to "AIR CLEANER .")