ECM Neutral Mode procedure (With Immobilizer)

• After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.

[If Installing A Used Ecm] 

1. Perform "ECM Neutral Mode" procedure using KDS/GDS.

   (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")

2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS/GDS.

   (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")

   [If installing a new ECM] 

   Perform "Key Teaching" procedure using KDS/GDS.

   (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")