ECM Neutral Mode Procedure (With Immobilizer)

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If Installing A Used ECM]
1. Perform "ECM Neutral Mode" procedure using KDS/GDS.
  (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS/GDS.
  (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
[If Installing A New ECM]

Perform "Key Teaching" procedure using KDS/GDS.

(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")