Repair Procedures: Removal

Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ").
Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.
Tightening torque :

33.3 - 43.1 N.m (3.4 - 4.4 kgf.m, 24.6 - 31.8 lb.ft)

Fig 1: Locating ATF Drain Plug
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: The existing ATF drain plug gasket must be replaced with a new one. (Do not reuse it.)
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Remove the wiring bracket (A) and the air breather hose (B).
Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 2: Locating Air Breather Hose And Wiring Bracket
Courtesy of KIA MOTORS AMERICA, INC.
Lift the vehicle after loosening valve body cover upper bolts.
Remove the valve body cover (A) by loosening bolts.
Tightening torque :

11.8 - 13.7 N.m (1.2 - 1.4 kgf.m, 8.7 - 10.1 lb.ft)

Fig 3: Locating Valve Body Cover
Courtesy of KIA MOTORS AMERICA, INC.
Remove the main harness (A) after removing the bolts.
Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 4: Locating Main Harness With Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Remove the valve body assembly (A) after loosening the bolts.
Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 5: Locating Valve Body Assembly With Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the speed sensor connector (A).

Fig 6: Locating Speed Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the speed sensor (A) after loosening the bolts.
Tightening torque :

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Fig 7: Locating Speed Sensor With Bolts
Courtesy of KIA MOTORS AMERICA, INC.