ECM Neutral Mode Procedure (With Immobilizer)

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If Installing a Used ECM]
1. Perform "ECM Neutral Mode" procedure using KDS.
  (Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")
2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS.
  (Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")
  
  [If Installing A New ECM]
  
  Perform "Key Teaching" procedure using KDS.
  
  (Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")