ECM Neutral Mode Procedure (With Immobilizer)

• After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.

[If Installing a Used ECM] 

1. Perform "ECM Neutral Mode" procedure using KDS.

   (Refer to REPAIR PROCEDURES - KEY TEACHING )

2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS.

   (Refer to REPAIR PROCEDURES - KEY TEACHING )

   [If Installing a New ECM] 

   Perform "Key Teaching" procedure using KDS.

   (Refer to REPAIR PROCEDURES - KEY TEACHING )