LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2018 >> Soul + >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L >> Injector >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

Fig 1: Locating Combustion Seal, Rubber Washer, Support Disc And O-Ring
G12239163Courtesy of KIA MOTORS AMERICA, INC.
  1. Combustion seal
  2. Rubber washer
  3. Support disc
  4. O-ring
NOTE:
  • Do not reuse the used injector fixing clip.
NOTE:
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
NOTE:
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
NOTE:
  • Do not reuse the used bolt.
NOTE:
  • When inserting the injector, be careful not to damage the injector tip.
NOTE:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the steal plate (A) part should face the cylinder installation part and the rubber plate (B) part should face the injector body part.
Fig 2: Locating Steal Plate And Rubber Plate
G12239164Courtesy of KIA MOTORS AMERICA, INC.
NOTE:
  • Do not reuse the combustion seal.
  1. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals