Repair Procedures: Replacement
- Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
- Remove the front muffler.
(Refer to Engine Mechanical System - "MUFFLER ")
- Disconnect the crankshaft position sensor connector (A).
- Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)
- Install in the reverse order of removal.
NOTE:
- Install the component to the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply the engine oil to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage it.