ECM Neutral Mode Procedure (With Smart Key)

After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If Installing a Used ECM]

Perform "ECM Neutral Mode" procedure using KDS.
(Refer to "Smart Key System - REPAIR PROCEDURES ")
After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
(Refer to "Smart key System - REPAIR PROCEDURES ")

[If Installing a New ECM]

Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.

(Refer to "Smart key System - REPAIR PROCEDURES ")