ECM Neutral Mode Procedure

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]

Perform "ECM Neutral Mode" procedure using KDS. (Refer to Body Electrical System - "REPAIR PROCEDURES ")
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS. (Refer to Body Electrical System - "REPAIR PROCEDURES ")
[If installing a new ECM]

Perform "Key Teaching" procedure using KDS. (Refer to Body Electrical System - "REPAIR PROCEDURES ")
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
  [If installing a used ECM]

Perform "ECM Neutral Mode" procedure using KDS. (Refer to Body Electrical System - "REPAIR PROCEDURES ")
After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]

Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.