Blind-Spot Collision Warning System DTCS
BLIND-SPOT COLLISION WARNING SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101 | 17: Battery Voltage High |
| DTC C1102 | 16: Battery Voltage Low |
| DTC C120A | 11: LED Right Circuit Short to Ground |
| DTC C120B | 15: LED Right Circuit Short to Battery or Open |
| DTC C120C | 11: LED Left Circuit Short to Ground |
| DTC C120D | 15: LED Left Circuit Short to Battery or Open |
| DTC C1283 | 81: Yaw Rate & G Sensor-Signal |
| DTC C1501 | 01: Switch Failure |
| DTC C150A | 15: Switch Circuit Failure |
| DTC C160A | 88: BCW Local CAN bus off |
| DTC C1611 | 87: CAN Time-out EMS |
| DTC C1612 | 87: CAN Time-out TCU |
| DTC C1613 | 81: CAN Wrong Message |
| DTC C1616 | 88: CAN Bus OFF (C-CAN) |
| DTC C1625 | 87: CAN Time-out ABS/ESC (ESP) |
| DTC C1628 | 87: CAN Time-out Cluster |
| DTC C1633 | 81: Cluster Invalid Displayed Speed |
| DTC C1642 | 81: CAN Message Failure - ABS/ESC (ESP) |
| DTC C1646 | 81: CAN Message Failure - TCU |
| DTC C1671 | 81: Signal Yaw Rate or Acceleration AX or Acceleration AY or Brake pressure State not valid |
| DTC C1675 | 81: Signal WHEEL_FL or WHEEL_FR or WHEEL_RL or WHEEL_RR not Valid |
| DTC C1702 | 55: Variant Coding Error |
| DTC C170A | 11: Activation Switch LED Circuit short to ground |
| DTC C170B | 12: Activation Switch LED Circuit short to battery or open |
| DTC C170C | 04: ECU Hardware error (REAR LEFT) |
| DTC C170D | 04: ECU Hardware error (REAR RIGHT) |
| DTC C1735 | 4B: Overtemperature Detected |
| DTC C1743 | 05: Software version LH/RH unmatching |
| DTC C1812 | 87: CAN Time-out Gateway |
| DTC C1816 | 87: CAN time-out SJB |
| DTC C2702 | 54: Control Module Missing Calibration |
| DTC C2703 | 54: Control Module Slave Missing Calibration |